CPI GTR180 Service Manual page 102

CPI MOTOR
X.ELECTRIC SYSTEM
Do not remove the aluminum sealing sheet "A"
from the filler ports "B" until just prior to use.
Be sure to use the dedicated electrolyte
container for correct electrolyte volume.
Place the battery on a level surface.
Check to see that the sealing sheet has no
peeling, tears, or holes in it.
REMOVE THE SEALING SHEET.
The battery is vacuum sealed.
If the sealing sheet has leaked air into the battery, it may
require a longer initial charge.
Remove the electrolyte container from the vinyl bag.
Detach the strip of caps "A" from the container and set
aside, these will be used later to seal the battery.
Do not pierce or otherwise open the sealed cells "B" of
the electrolyte container.
Do not attempt to separate individual cells.
Place the electrolyte container upside down with the six
sealed cells into the filler ports of the battery.
Hold the container level, push down to break the seals
of all six cells.
You will see air bubbles rising into each cell as the ports
fill.
Do not tilt the electrolyte container.
NOTE
NOTE
NOTE
《 10-8 》
GTR180