CPI GTR180 Service Manual page 88

CPI MOTOR GTR180
IX.DRIVE AND DRIVEN PULLEYS & KICK STARTER
Measure drive face I.D.
Measure the inner diameter of movable drive face. Replace
for new if necessary.
Install weight roller.
NOTE
There are 2 different sides of weight roller, in order to
extend the part life ad avoid the extraordinary worm,
please put close side of weight roller on movable drive
face by anticlockwise direction.
Install the three slide pieces to ramp plate.
Install the ramp plate.
Install:
1. Slide pieces [A]
2. Ramp plate [B]
Smear a little grease inside of drive face shaft hole.
Install the drive face boss.
ATTENTION!!!
It can not have any grease on belt and surface of drive
face, it can use grease stripper to clean the unnecessary
grease.
Install drive face comp. to crankshaft.
《9 -14 》