CPI GTR180 Service Manual page 89

CPI MOTOR GTR180
IX.DRIVE AND DRIVEN PULLEYS & KICK STARTER
DRIVE FACE ASSEMBLY
Install drive belt to drive face
Tighten up per torque standard.
Torque：5.0~6.0kgf-m
DISASSEMBLY DRIVEN PULLEY ASSY.
Disassemble the drive face and driven pulley assy.
Install the clutch spring condenser to driven pulley assy.
then tighten it for fitting with nut easily.
Per picture to put the clutch spring condenser on vise and
use special wrench dismount the nut.
Loosen the driven pulley spring condenser, disassemble the
driven pulley and spring from drive face.
Dismount the oil seal cover from drive face.
Dismount the oil seal cover from driven face assy.
Disassemble the guide pin, roller guide pin & movable
driver face, dismount the O-ring and oil seal gasket from
driver face.
《9 -15 》