Minolta magicolor 7300 User Manual page 123

How do I replace the paper separator roller for Tray 1?
The following procedure describes the replacement of the paper separator
roller for Tray 1.
1
Remove the two screws from the
outer-right side of the tray, as
shown, and then remove the paper
separator roller.
The paper separator roller is
attached to the two reinforcing
plates on the opposite side of
the screws. When the screws
are removed, the reinforcing
plates will fall. Therefore, catch
the reinforcing plates with your
hand when removing the
screws.
2
Take out the new paper separator roller.
Place the used paper separator roller in the packing for the new paper
separator roller.
Do not throw away the box and plastic bag that the new paper separa-
tor roller was packed in.
They will be reused to pack the used paper separator roller.
WARNING!
Contact toner_recycle@minolta-qms.com for recycling
availability. Do not throw away.
3
Attach the new paper separator
roller to the tray.
Before tightening the screws, be
sure that the pins on the rein-
forcing plates are toward the
back of the tray.
4
Close the tray.
Replacing Media Pickup and Separator Rollers
115