Minolta magicolor 7300 User Manual page 124

How do I replace the paper separator roller for Tray 2 and
optional Tray 3/4?
The paper separator roller should also be replaced at the same time that the
paper take-up roller is replaced. The following procedure describes the
replacement of the paper separator roller for the standard media tray (Tray 2)
and the optional media trays (Trays 3 and 4).
1
Remove the two screws from the
outer-right side of the tray, as
shown, and then remove the paper
separator roller.
2
Take out the new paper separator roller.
Place the used paper separator roller in the packing for the new paper
separator roller.
3
Attach the new paper separator
roller to the tray.
Do not throw away the box and
plastic bag that the new paper
separator roller was packed in.
They will be reused to pack the
used paper separator roller.
Attention
Contact toner_recycle@minolta-qms.com for recycling
availability. Do not throw away.
4
Close the tray.
116 Replacing Media Pickup and Separator Rollers