Minolta magicolor 7300 User Manual page 197

Symptom Cause
Not all pages The duplex unit is not
in an auto- installed.
duplexed job
print back-to-
The printer driver is not
back.
set correctly.
Several The front edges of the
sheets go media are not even.
through the
Too much static
printer
electricity is present.
together.
Media jam The printer needs to be
message reset.
stays on.
Some media remains
jammed in the printer.
Duplex jams The wrong media is
occur. being used.
Media may still be
jammed.
If you are manually
duplexing, media jams
may occur if the printed
sheet(s) that are
reinserted are not
entirely flat.
Solving Problems
Solution
For autoduplexing, make sure that you
have the duplex option and manual feed
tray installed.
Select the proper driver setting.
Remove the media and even up the front
edges, then reload it.
Remove the media from the tray and check
for static electricity. Fan the media (but not
transparencies), and replace it in the tray.
Open and close the side door.
Recheck the media path and make sure
you have removed all of the media jams.
Use only supported media. See "Media
Types" on page 15.
Plain paper up to 24 lb bond (90 g/m²) can
be automatically duplexed if the optional
duplex unit is installed and selected in the
driver.
Autoduplexing is not supported for thicker
media or transparencies.
To manually duplex, remove the media, flip
it over, and reload it.
Make sure that you have not mixed media
types in your media tray.
Recheck the media path inside the duplex
unit and make sure that you have removed
all of the jammed media.
Remove the jammed media from the tray,
flatten it out, and then reload it.
189