Minolta magicolor 7300 User Manual page 212

This message...
TRAY TYPE ERR
ADD MEDIA
COVER OPEN
CHECK Y
FUSER LOW
FUSER MISSING
CHECK UNIT
MANL FEED ERROR
REMOVE MEDIA
MEDIA EMPTY
ADD X
MEDIA JAM
Y
204
means...
The transparency
sensor detects the
tray (TRAY) has
transparency media,
but the driver
selection is not
Transparency, or the
tray has other media
(MEDIA) than
transparency, but the
driver selection is
Transparency.
Printer's door (Y) is
open and must be
closed.
The fuser is nearing
the end of its life.
The fuser is missing
or is not correctly
installed.
Media is inserted in
the manual feed tray
during duplex printing
from another tray.
The tray is out of
media size (X).
There is a media jam
in the specified
location (Y).
Control Panel Messages
do this...
Install MEDIA (media
type) and make sure
driver is set correctly.
Remove and insert the
tray before resuming
printing.
Close the specified door.
Replace the fuser.
Open the side door and
make sure the fuser has
been installed. If
necessary, install the
fuser unit and close the
side door.
Remove the media in
the manual feed tray.
Install the specified
media size into any tray.
Locate and remove the
jam.