Configuring For Appletalk Using Epsonnet Winassist - Epson aculaser c2000 Administrator's Manual

Network Number for Manual Mode:
Enter a value between 0 and 65534 when Manual is selected
for the Network Number Set.
6. After making settings, click Send . The Password dialog box
appears.
7. Type your password (up to 20 characters) and click OK to save
settings. If you need to set a password, see "About
passwords" on page 9-19.
After updating is complete, refresh the configuration. To do
this, quit EpsonNet MacAssist once, then start EpsonNet
MacAssist again.
c
Caution:
Since it takes 2 or 3 minutes to send new settings to the
Internal Print Server, you must wait until after the on-
screen message appears to turn off your printer.
Configuring for AppleTalk Using EpsonNet
WinAssist
Follow the steps to configure the Internal Print Server using
EpsonNet WinAssist from Windows environment.
Note:
To configure for AppleTalk with EpsonNet WinAssist, the Internal
Print Server must have a valid IP address or you must have logged in
to the NetWare server or NDS context as an ADMIN.
1. Turn on the printer.
2. Start EpsonNet WinAssist.
Windows 98/95/2000/NT 4.0: Click Start, point to Programs ,
EpsonNet WinAssist , then click EpsonNet WinAssist .
Settings for Macintosh
6
6-5