Setting Up Your Printer; Adding A Printer Located In The Same Segment - Epson aculaser c2000 Administrator's Manual

Setting Up Your Printer

When setting up a printer to print with LPR, you can add both a
printer located in the same segment and one located beyond a
router.
Note:
❏ Be sure that the computer is connected to the network and TCP/IP
is correctly set.
❏ The valid IP address other than default value "192.168.192.168"
must be set; otherwise the printer does not appear under the
Epson_lpr group icon. See "Setting the IP Address Using EpsonNet
WinAssist/MacAssist" on page 2-8 to set the IP address.
❏ The EPSON Status Monitor 2 utility shipped with the interface card
models C82362 ✽ /C82363 ✽ /C82364 ✽ with software version 1.x
and EPL-N2700/N4000 printers enables EPSON TCP/IP printers.
These EPSON TCP/IP printers can coexist with lpr printers added
by EpsonNet Direct Print.
❏ Job control functions, such as pause printing, cancel printing, and
purge print job, can be accessed by double-clicking the printer icon
in the Printers folder.

Adding a printer located in the same segment

1. Windows 98/95/NT 4.0: Double-click the Network
Neighborhood icon.
Windows 2000: Double-click the My Network Places icon.
Double-click the Entire Network icon, click entire contents,
and then double-click the EpsonPeripheralNetwork icon.
2. Right-click the Epson_lpr icon and select Properties. The
Epson_lpr Properties dialog box appears.
10-4
EpsonNet Direct Print