Epson aculaser c2000 Administrator's Manual page 29

Note:
❏ The default value for the IP address, subnet mask, and default
gateway are 192.168.192.168, 255.255.255.0, and
255.255.255.255 respectively.
❏ If there is a server or a router which functions as a gateway, type
the IP address of the server or router for the gateway address. If
there is no gateway, leave the default values.
❏ The Set by PING check box is not available. If you want to set
the IP address using arp/ping commands, use printer's control
panel to select PING for Get IP Address in Network Menu.
8. After making the settings, click OK (for WinAssist) or Send
(for MacAssist). The Password dialog box appears.
9. Type your password (up to 20 characters) and click OK to save
settings. If you are entering a password for the first time, click
Change and set the password. For more information about
passwords, see "About passwords" on page 9-9 for EpsonNet
WinAssist or "About passwords" on page 9-19 for EpsonNet
MacAssist.
Follow the on-screen instructions. After updating is complete,
refresh the configuration by selecting Refresh from the View
menu (for WinAssist), or by quitting MacAssist and then
restarting it (for MacAssist).
c
Caution:
Since it takes 2 or 3 minutes to send new settings to the
Internal Print Server, you must wait until after the on-
screen message appears to turn off your printer.
10. Be sure to print a network status sheet to confirm the new IP
address.
Connecting to the Network
2
2-11