Epson aculaser c2000 Administrator's Manual page 261

The message "TCP/IP cannot be used." appears when you start
EpsonNet WinAssist.
Cause
TCP/IP is not installed in the
computer.
The computer's IP address is
not set correctly.
The message "Could not complete communicating
configuration data" appears when you send settings to the
Internal Print Server.
Cause
You are using a dial-up
router.
What to do
Install the TCP/IP protocol.
Set the IP address for the computer.
What to do
Run Command Prompt from the
computer in which EpsonNet
WinAssist/MacAssist is installed,
then type the following command;
Format: >ROUTE_ADD_the IP
address of the Internal Print Server_
the IP address of the computer (the
under bar represents one space)
Example: >ROUTE ADD
192.168.192.168 22.33.44.55.
Troubleshooting
15
15-3