Removing The Gear Position Sensor; Removing The Engine; Installing The Engine - Yamaha 2013 FJR1300AS Service Manual

EAS1MD1028

REMOVING THE GEAR POSITION SENSOR

1. Disconnect:
• Gear position sensor coupler
2. Remove:
• Gear position sensor
TIP
Remove only the screws "1" when removing the
gear position sensor. Do not remove the screws
"2".
2
EAS1MC1066

REMOVING THE ENGINE

1. Loosen:
• Spacer bolt
TIP
Loosen the spacer bolt with the pivot shaft
wrench "1" and pivot shaft wrench adapter "2".
Pivot shaft wrench
90890-01471
Frame spanner socket
YM-01471
Pivot shaft wrench adapter
90890-01476
2. Remove:
• Engine
TIP
Make sure that the engine does not strike the
clutch actuator "1" when removing it.
EAS23720

INSTALLING THE ENGINE

1
1. Install:
2
• Rubber damper
1
TIP
The arrow mark "a" on the rubber damper should
face up.
2. Install:
• Engine
TIP
• Fit the rubber damper "a" into the hole "b" in the
clutch actuator bracket.
• When mounting the engine to the frame, be
sure to align the splines on the middle driven
shaft with the splines on the universal joint.
3. Install:
• Spacer bolt "1"
• Engine mounting bolt (rear upper side) "2"
• Spacer "3"
• Engine mounting bolt (rear lower side) "4"
5-8
ENGINE REMOVAL
1
a
a
b