Yamaha 2013 FJR1300AS Service Manual page 720

ELECTRONICALLY ADJUSTABLE SUSPENSION SYSTEM
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Probable cause of mal-
Item
function and check
1 Circuit breaker in the DC mo-
tor operates.
(Preload was adjusted re-
peatedly.)
2 Connection of rear shock ab-
sorber assembly DC motor
coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
94
Preload adjusting motor (rear shock absorber assembly DC
motor) is locked, rotary encoder signal is not received, encod-
er signal is reversed, or motor rotates continuously at a low
speed during the diagnostic mode (code No. 84 [preload home
position adjustment]).
Able to start engine
Able to drive vehicle
84
When completed successfully
"00" is displayed in the multi-function meter right display and the
electronically adjustable suspension system warning light goes off.
The preload is adjusted to the solo-riding position.
When not completed successfully
"F0" is displayed in the multi-function meter right display and the
electronically adjustable suspension system warning light remains
on. Remove the rear shock absorber assembly DC motor and ad-
just it by hand.
After adjusting the DC motor, perform the procedure for diagnostic
code No. 84 again. If "F0" is displayed again, replace the rear
shock absorber assembly.
To adjust the preload home position, simultaneously press the
"TCS" button and "RESET" button for 2 seconds.
Maintenance job
After adjusting the preload,
wait 6 minutes or more be-
fore adjusting it again.
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
8-249
Confirmation of service
completion
Start the engine, adjust the
preload (solo riding → solo
riding and luggage), and
then check whether a fault
code number is displayed.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 2.
Turn the main switch to
"OFF" and back to "ON",
start the engine, adjust the
preload (solo riding → solo
riding and luggage), and
then check whether a fault
code number is displayed.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 3.