Yamaha 2013 FJR1300AS Service Manual page 53

Instantaneous fuel consumption display:
FUEL CRNT
The instantaneous fuel consumption display
modes "km/L", "L/100km" or "MPG" (for the UK
only) show the fuel consumption under the cur-
rent riding conditions.
• The "km/L" display shows the distance that can
be traveled on 1.0 L of fuel.
• The "L/100km" display shows the amount of
fuel necessary to travel 100 km.
• For the UK only: The "MPG" display shows the
distance that can be traveled on 1.0 Imp.gal of
fuel.
TIP
If traveling at speeds under 10 km/h (6 mi/h), "_
_._" will be displayed.
Adjusting the windshield position
To move the windshield up, push the "
of the select switch. To move the windshield
down, push the " " side of the select switch.
Setting mode
MENU
Grip Warmer
Maintenance
Time Trip
Unit
Display
Brightness
Clock
1. Setting mode display
TIP
• The transmission must be in neutral and the
vehicle must be stopped to change settings in
this mode.
• Shifting the transmission into gear and starting
off, or turning the main switch to "OFF", saves
all settings made, then exits the setting mode.
km/L
12.3
" side
1
Push and hold the menu switch "MENU" for at
least 2 seconds to enter the setting mode. To
exit the setting mode and return to the normal
display, push and hold the menu switch "MENU"
again for at least 2 seconds.
Display
"Grip Warmer"
"Maintenance"
"Time Trip"
"Unit"
"Display"
"Brightness"
"Clock"
1-44
FEATURES
Description
This function allows you to
set the low, middle, and high
settings to 10 temperature
levels.
This function allows you to
check and reset the "OIL" oil
change interval (distance
traveled), and the "FREE-1"
and "FREE-2" maintenance
intervals.
This function allows you to
check and reset the "TIME-
2" and "TIME-3" functions.
These time trips show the to-
tal elapsed time that the key
has been in the "ON" posi-
tion. When the key is turned
to "OFF", the time trips stop
counting but are not reset.
The maximum time that can
be shown is 99:59.
When the time trips reach
99:59, they automatically re-
set to 0.00 and continue
counting.
This function allows you to
switch the fuel consumption
units between "L/100km"
and "km/L".
For the UK only: This func-
tion allows you to switch the
display units between kilo-
meters and miles. When ki-
lometers are selected, the
fuel consumption units can
be switched between
"L/100km" and "km/L".
This function allows you to
change the items shown in 3
information displays.
This function allows you to
adjust the brightness of the
multi-function meter unit
panel to suit the outside
lighting conditions.
This function allows you to
set the clock.