Yamaha 2013 FJR1300AS Service Manual page 705

Fault code No.
Item
3 Installed condition of gear
position sensor.
4 Clutch slips.
TIP
*3:If any of the following fault codes are detected, do not execute the diagnostic mode "Sh_ _65".
Sh_ _11, Sh_ _12, Sh_ _13, Sh_ _14, Sh_ _15, Sh_ _16, Sh_ _17, Sh_ _18, Sh_ _19, Sh_ _21,
Sh_ _25, Sh_ _26, Sh_ _32, Sh_ _36, Sh_ _37, Sh_ _44, Sh_ _45, Sh_ _46, Sh_ _48, and Sh_ _51
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Probable cause of mal-
Item
function and check
1 Connection of shift actuator
sensor coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
2 Connection of MCU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
YCC-S (Yamaha Chip Controlled-Shift) SYSTEM
Sh_ _49
Engine speed is too high when vehicle is started.
Refer to "ADJUSTING THE
GEAR POSITION SEN-
SOR" on page 5-11.
Sensor output voltage when
neutral indicator light is on:
0.71–0.91 V
Out of specification → Adjust
the gear position sensor
again, or replace the sensor
and carry out the learning for
each gear position. Execute
the diagnostic mode. (Code
No. Sh_ _65)
Check the friction plates.
Refer to "CHECKING THE
FRICTION PLATES" on page
5-51.
Sh_ _51
Detected position of shift actuator sensor is incorrect.
Unable to start
Unable to change the shift
—
—
—
Maintenance job
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
8-234
Malfunction is repaired →
Service is finished.
Malfunction could not be
found → Go to item 4.
Confirmation of service
completion
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Check the operation of the
shift actuator.
Fault code number is dis-
played → Go to item 2.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Check the operation of the
shift actuator.
Fault code number is dis-
played → Go to item 3.