Yamaha 2013 FJR1300AS Service Manual page 672

TIP
*1
: If any of the following fault codes are detected, do not execute the diagnostic mode "Sh_ _63".
Sh_ _11, Sh_ _12, Sh_ _13, Sh_ _15, Sh_ _16, Sh_ _17, Sh_ _25, Sh_ _26, Sh_ _36, Sh_ _37,
and Sh_ _44
*2
: If any of the following fault codes are detected, do not execute the diagnostic mode "Sh_ _64".
Sh_ _11, Sh_ _12, Sh_ _14, Sh_ _15, Sh_ _16, Sh_ _18, Sh_ _19, Sh_ _25, Sh_ _37, and Sh_ _51
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Probable cause of mal-
Item
function and check
1 Connection of clutch actua-
tor motor coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
YCC-S (Yamaha Chip Controlled-Shift) SYSTEM
Sh_ _17
Detected clutch actuator position is incorrect.
Unable to start
Unable to change the shift
*1
Sh_ _63
Engagement position: Shift down indicator light comes on
Disengagement position: Shift down indicator light goes off
Other position: Shift down indicator light will flash
Operate the hand shift lever switch (shift up) and the brake lever or
brake pedal at the same time.
Maintenance job
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
8-201
Confirmation of service
completion
Check the indication of the
shift down indicator light
when the clutch is engaged
and disengaged. Execute the
diagnostic mode. (Code No.
Sh_ _63)
The indication of the shift
down indicator light changes
(the light comes on or goes
off) according to the switch
operation. → Service is fin-
ished.
The shift down indicator light
flashes or the indication of
the light does not change
(the light does not come on
or go off) according to the
switch operation. → Go to
item 2.