Yamaha 2013 FJR1300AS Service Manual page 699

Fault code No.
Item
5 Abnormal clutch stroke.
6 Stuck shift actuator.
7 Defective shifting system.
TIP
*1:If any of the following fault codes are detected, do not execute the diagnostic mode "Sh_ _63".
Sh_ _11, Sh_ _12, Sh_ _13, Sh_ _15, Sh_ _16, Sh_ _17, Sh_ _25, Sh_ _26, Sh_ _36, Sh_ _37,
and Sh_ _44
*2:If any of the following fault codes are detected, do not execute the diagnostic mode "Sh_ _64".
Sh_ _11, Sh_ _12, Sh_ _14, Sh_ _15, Sh_ _16, Sh_ _18, Sh_ _19, Sh_ _25, Sh_ _37, and Sh_ _51
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Probable cause of mal-
Item
function and check
YCC-S (Yamaha Chip Controlled-Shift) SYSTEM
Sh_ _45
Shift operation and gear position do not match.
Check the clutch stroke.
Refer to "BLEEDING THE
HYDRAULIC CLUTCH SYS-
TEM" on page 3-12.
Refer to "CHECKING FOR
STUCK SHIFT ACTUATOR"
on page 5-66.
Remove the shift rod, and
then rotate the rear shift arm
by hand and confirm that it is
not stuck.
If the rear shift arm is stuck
→ Replace the shift actuator.
If the rear shift arm is not
stuck → Check the shift
mechanism.
Refer to "SHIFT ACTUATOR
AND SHIFT ROD" on page
5-61.
Check and repair the shifting
system.
Refer to "SHIFT ACTUATOR
AND SHIFT ROD" on page
5-61.
Sh_ _46
Detected position of gear position sensor is incorrect.
Able/Unable to start
Able/Unable to change the shift
—
—
—
Maintenance job
8-228
Malfunction is repaired →
Service is finished.
Malfunction could not be
found → Go to item 6.
Check the indication of the
shift down indicator light
when the transmission is
shifted up and down. Exe-
cute the diagnostic mode.
(Code No. Sh_ _64)
Transmission is shifted up or
down: Shift down indicator
light comes on → Service is
finished.
Transmission is shifted up or
down: Shift down indicator
light will flash → Go to item
7.
Confirmation of service
completion