Removing The Crankshaft Position Sensor; Installing The Crankshaft Position Sensor - Yamaha 2011 FZ8NA(C) Service Manual

EAS24530
REMOVING THE CRANKSHAFT POSITION
SENSOR
1. Disconnect:
• Crankshaft position sensor lead coupler
2. Remove:
• Crankshaft position sensor
• O-rings
• Pickup rotor cover "1"
TIP
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern.
After all of the bolts are fully loosened, remove
them.
EAS24540
INSTALLING THE CRANKSHAFT POSITION
SENSOR
1. Install:
• Gasket New
• Pickup rotor cover "1"
Pickup rotor cover bolt
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
• O-rings
New
• Crankshaft position sensor
Crankshaft position sensor bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
CRANKSHAFT POSITION SENSOR
2. Connect:
• Crankshaft position sensor lead coupler
5-40