Checking The Abs Warning Light - Yamaha 2013 FJR1300AS Service Manual

11.After the pulsating action has stopped in the
brake lever, it is generated in the brake pedal
"1" 0.5 second later and continues for approx-
imately 2 seconds.
TIP
• The reaction-force pulsating action consists of
quick pulses.
• Be sure to continue operating the brake lever
and brake pedal even after the pulsating action
has stopped.
12.After the pulsating action has stopped in the
brake pedal, it is generated in the brake lever
0.5 second later and continues for approxi-
mately 1.5 seconds.
TIP
The reaction-force pulsating action consists of
quick pulses.
ECA3P6D020
NOTICE
• Check that the pulsating action is felt in the
brake lever, brake pedal, and again in the
brake lever, in this order.
• If the pulsating action is felt in the brake
pedal before it is felt in the brake lever,
check that the brake hoses and brake pipes
are connected correctly to the hydraulic
unit assembly.
• If the pulsating action is hardly felt in either
the brake lever or brake pedal, check that
the brake hoses and brake pipes are con-
nected correctly to the hydraulic unit as-
sembly.
1
ABS (ANTI-LOCK BRAKE SYSTEM)
13.Turn the main switch to "OFF".
14.Remove the test coupler adapter from the
ABS test coupler.
15.Turn the main switch to "ON".
16.Shift the transmission into neutral and retract
the sidestand.
17.Check for brake fluid leakage around the hy-
draulic unit.
Brake fluid leakage → Replace the hydraulic
unit, brake pipes, and related parts as a set.
EAS1MC1084

CHECKING THE ABS WARNING LIGHT

After all checks and servicing are completed, en-
sure that the ABS warning light goes off by walk-
ing the vehicle at a speed of faster than 7 km/h
(4.4 mph) or performing a trial run.
4-74