ET2D21003
REMOVING THE GEAR POSITION SENSOR
1. Disconnect:
• Gear position sensor coupler
2. Remove:
• Gear position sensor
NOTE:
Remove only the screws "1" when removing the
gear position sensor. Do not remove the screws
"2".
2
ET3P61023
REMOVING THE ENGINE
1. Loosen:
• Spacer bolt
NOTE:
Loosen the spacer bolt with the pivot shaft
wrench "1" and pivot shaft wrench adapter "2".
Pivot shaft wrench
90890-01471
Frame spanner socket
YM-01471
Pivot shaft wrench adapter
90890-01476
2. Remove:
• Engine
NOTE:
Make sure that the engine does not strike the
clutch actuator "1" when removing it.
ET2D21004
INSTALLING THE GEAR POSITION SENSOR
1
1. Connect:
2
• MCU coupler
1
• ECU coupler
2. Install:
• Gear position sensor "1"
EC2D21002
CAUTION:
Shift the transmission into neutral before in-
stalling the gear position sensor, otherwise
the sensor may be damaged.
NOTE:
Fit the end "a" of the shift drum assembly into the
opening "b" in the gear position sensor "1", and
then rotate the sensor counterclockwise and
temporarily install the screws.
3. Adjust:
• Gear position sensor
– 49 –
ENGINE REMOVAL
1
Refer to "GENERAL CHASSIS" on page 37.
a
Refer to "ADJUSTING THE GEAR POSI-
TION SENSOR" on page 50.
1
b