Yamaha 2013 FJR1300AS Service Manual page 765

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
07 Rear wheel vehicle speed
pulses
08 Lean angle sensor
• Upright
• Overturned
09 Fuel system voltage
(battery voltage)
13 Throttle position sensor
signal 2
• Fully closed position
• Fully open position
14 Accelerator position sen-
sor signal 1
• Fully closed position
• Fully open position
15 Accelerator position sen-
sor signal 2
• Fully closed position
• Fully open position
16 Front wheel vehicle speed
pulses
20 Sidestand switch
• Stand retracted
• Stand extended
Item
Rear wheel speed pulse
0–999
Lean angle sensor output
voltage
0.4–1.4
3.7–4.4
Approximately 12.0
9–23
94–108
12–22
97–107
10–24
95–109
Front wheel speed pulse
0–999
ON
OFF
Meter display
9-8
(ECU)
Procedure
Check that the number in-
creases when the rear
wheel is rotated. The num-
ber is cumulative and
does not reset each time
the wheel is stopped.
Remove the lean angle
sensor and incline it more
than 65 degrees.
Set the start/engine stop
switch to " ", and then
compare the actually mea-
sured battery voltage with
the meter display value. (If
the actually measured bat-
tery voltage is low, re-
charge the battery.)
Check with throttle valves
fully closed.
Check with throttle valves
fully open.
Check with throttle grip ful-
ly closed position.
Check with throttle grip ful-
ly open position.
Check with throttle grip ful-
ly closed position.
Check with throttle grip ful-
ly open position.
Check that the number in-
creases when the front
wheel is rotated. The num-
ber is cumulative and
does not reset each time
the wheel is stopped.
Extend and retract the sid-
estand (with the transmis-
sion in gear).