Yamaha 2013 FJR1300AS Service Manual page 774

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnos-
tic code Item
No.
Sh_ _65 Gear position setting
TIP
If any of the following
fault codes are de-
tected, do not exe-
cute the diagnostic
mode.
Sh_ _11, Sh_ _12,
Sh_ _13, Sh_ _14,
Sh_ _15, Sh_ _16,
Sh_ _17, Sh_ _18,
Sh_ _19, Sh_ _21,
Sh_ _25, Sh_ _26,
Sh_ _32, Sh_ _36,
Sh_ _44, and Sh_
_45, Sh_ _46, Sh_
_48, and Sh_ _51
Meter display
Carries out the
learning for each
gear position.
9-17
Procedure
The gear position can be set in this mode.
1. Make sure that the transmission is in
neutral.
2. Push the stop mode function switch. If
the gear position sensor output signal is
correct for the neutral position, the shift
down indicator light will come on for 0.5
second.
3. Shift the transmission into 1st gear us-
ing the hand shift lever (shift up), and
then rotate the rear wheel at least 1/2
turn by hand to ensure that the dog
completely engages the 1st gear.
4. Push the stop mode function switch. If
the gear position sensor output signal is
correct for the 1st gear position, the
shift down indicator light will come on
for 0.5 second.
5. Repeat steps 3 and 4 for each gear up
to the 5th gear and make sure that the
shift down indicator light comes on for
0.5 second each time the stop mode
function switch is pushed.
6. Shift the transmission into 4th gear us-
ing the hand shift lever (shift down), and
then rotate the rear wheel at least 1/2
turn by hand to ensure that the dog
completely engages the 4th gear.
7. Push the stop mode function switch. If
the gear position sensor output signal is
correct for the 4th gear position, the
shift down indicator light will come on
for 0.5 second.
8. Repeat steps 6 and 7 for each gear
down to the 1st gear and make sure
that the shift down indicator light comes
on for 0.5 second each time the stop
mode function switch is pushed.
9. Shift the transmission into neutral.
10. Push the stop mode function switch. If
the gear position sensor output signal is
correct for the neutral position, the shift
down indicator light will come on for 0.5
second.
11. After the above procedure is complet-
ed, all of the gear position data is tem-
porarily stored and ready to be written
on EEPROM.
(MCU)