Yamaha 2013 FJR1300AS Service Manual page 512

• To increase the selected diagnostic code number, press the "TCS" button. Press the "TCS" button for
1 second or more to automatically increase the diagnostic code numbers.
a
b
a. Diagnostic code number increases.
b. Diagnostic code number decreases.
8. Check the operation of the sensor or actuator.
• Sensor operation
The data representing the operating conditions of the sensor appears on the multi-function meter
right display.
• Actuator operation
To operate the actuator, set the start/engine stop switch from"
TEM)
To operate the actuator, simultaneously operate the hand shift lever and brake lever or brake pedal.
(YCC-S (Yamaha Chip Controlled-Shift) system)
To operate the actuator, simultaneously press the "TCS" button and "RESET" button for approxi-
mately 2 seconds. (ELECTRONICALLY ADJUSTABLE SUSPENSION SYSTEM)
9. Turn the main switch to "OFF" to cancel the diagnostic mode.
TIP
Information about each diagnostic code number is organized in this manual as follows:
• If a diagnostic code number has a corresponding fault code number, the information is shown in
"TROUBLESHOOTING DETAILS (ECU)". (Refer to "TROUBLESHOOTING DETAILS (ECU)" on
page 8-43.)
• If a diagnostic code number does not have a corresponding fault code number, the information is
shown in "DIAGNOSTIC CODE TABLE". (Refer to "SELF-DIAGNOSTIC FUNCTION AND DIAG-
NOSTIC CODE TABLE (ECU)" on page 9-5, "SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC
CODE TABLE (MCU)" on page 9-13, and "SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC
CODE TABLE (SCU)" on page 9-19.)
10.Connect the wire harness coupler to the fuel pump. (except for electronically adjustable suspension
system)
EAS1MC1036
YAMAHA DIAGNOSTIC TOOL
This model uses the Yamaha diagnostic tool to identify malfunctions.
For information about using the Yamaha diagnostic tool, refer to the operation manual that is
included with the tool.
Yamaha diagnostic tool
90890-03215
Features of the Yamaha diagnostic tool
You can use the Yamaha diagnostic tool to identify malfunctions quicker than with conventional
methods.
By connecting the adapter interface, which is connected to the USB port of a computer, to a vehicle's
FUEL INJECTION SYSTEM
DIAG
DIAG
DATA
" to "
8-41
01
15
". (FUEL INJECTION SYS-