Removing The Side Cowlings; Installing The Side Cowlings - Yamaha 2013 FJR1300AS Service Manual

1
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
3. Install:
• Headlight beam adjusting knob "1"
TIP
Align the flat portion "a" of the hole in the head-
light beam adjusting knob with the flat portion "b"
of the headlight beam adjusting knob joint.
EAS1MC1058

REMOVING THE SIDE COWLINGS

The following procedure applies to both of the
side cowlings.
1. Remove:
• Side cowling "1"
TIP
Unhook the projections on the side cowling from
the front cowling.
1
EAS1MC1059

INSTALLING THE SIDE COWLINGS

1. Install:
• Left side cowling "1"
d
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
b a
1
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Connect the front left turn signal light coupler,
auxiliary DC jack coupler, and accessory box
solenoid coupler, and then fasten the front left
turn signal light lead "a", auxiliary DC jack
lead "b", and accessory box solenoid lead "c"
with a plastic locking tie.
TIP
Make sure that the couplers are aligned as
shown in the illustration.
▲▲▲
b. Fit the projections on the left side cowling into
the holes in the front cowling.
d. 70–120 mm (2.8–4.7 in)
▲ ▲▲▲ ▲ ▲▲▲ ▲
2. Install:
• Right side cowling "1"
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Connect the front right turn signal light cou-
pler, and then fasten the front right turn signal
light lead "a" with the holder "b" on the right
side cowling.
TIP
Make sure that the lower edge of the white tape
"c" on the front right turn signal light lead is
aligned with the upper edge of the holder.
b. Fit the projections on the right side cowling
into the holes in the front cowling.
▲ ▲▲▲ ▲ ▲▲▲ ▲
4-9
GENERAL CHASSIS
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
1
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
1
a
c
b
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼▼▼
b
c
a
d
▲ ▲▲▲ ▲ ▲▲▲
▼ ▼▼▼ ▼ ▼▼▼
▲ ▲▲▲ ▲ ▲▲▲