Yamaha 2013 FJR1300AS Service Manual page 258

e. Retract the sidestand.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
3. Remove:
• Right upper inner panel
Refer to "GENERAL CHASSIS" on page 4-1.
4. Check:
• Battery voltage
Lower than 12.8 V → Charge or replace the
battery.
Battery voltage
Higher than 12.8 V
TIP
• If the battery voltage is lower than 12.8 V,
charge the battery, and then perform hydraulic
unit operation test 2.
• If the battery voltage is lower than 10 V, the
ABS warning light comes on and the ABS does
not operate.
5. Connect the test coupler adapter "1" to the
ABS test coupler "2".
Test coupler adapter
90890-03149
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
2
1
ABS (ANTI-LOCK BRAKE SYSTEM)
6. Extend the sidestand.
7. Turn the main switch to "ON".
▲▲▲
8. Push the "
switch "1" for at least 4 seconds.
ECA14790
NOTICE
Do not operate the brake lever or the brake
pedal.
9. After releasing the start/engine stop switch,
operate the brake lever and the brake pedal
simultaneously.
10.A reaction-force pulsating action is generated
in the brake lever "1" 0.5 second after the
brake lever and the brake pedal are operated
simultaneously and continues for approxi-
mately 1.5 seconds.
TIP
• The reaction-force pulsating action consists of
quick pulses.
• Be sure to continue operating the brake lever
and brake pedal even after the pulsating action
has stopped.
4-73
" side of the start/engine stop
1
1