Repacking The Printer - 3D Systems cube User Manual
This printer is portable with a plug and print design that enables everybody in the family
to express their creativity like never before
Hide thumbs
Also See for cube:
- User manual (121 pages) ,
- Quick start manual (32 pages) ,
- Lesson (15 pages)
Table of Contents
Advertisement
NOTE: If the firmware update fails. Select
install the firmware again. Select
update the firmware.
5 .
When prompted, press and release the
turns on .
NOTE: It may take a minute for the display to turn on .
6 .
Perform the Auto Level and Auto Gap procedures .
NOTE: For more information, refer to the section titled
Calibration .
REPACKING THE PRINTER
If the printer should ever need to be transported, the printer must be properly repackaged using the original packaging materials . If
you no longer have your original packaging materials, contact cubifysupport@cubify .com for assistance in obtaining the appropriate
packaging materials .
1 .
Power off the printer by pressing and holding the button next to the touchscreen
display .
2 .
Disconnect the power cord from utility power and disconnect the cord from the
power supply .
3 .
Disconnect the power supply cable from the printer's power inlet (A) .
NOTE: The power supply cable is designed to lock in place . To
remove the cable, pull the outer sleeve back to release it and then
continue to pull the cable from the printer .
4 .
Securely repack all of the accessories into the accessories box .
NOTE: Refer to the contents list in the section titled Unpacking and
Setting Up Your Cube .
3D Systems, Inc.
RETRY
to attempt to
CANCEL
if you do not want to
power button
and wait until the display
Print Pad
94
A
Advertisement
Table of Contents
