3D Systems cube User Manual page 33

4 . Apply two thin layers of Cube Glue to the center of the print pad . Select the
checkmark to continue .
NOTE: Ensure that the area where glue is applied is larger than the
dimensions of the base of your creation .
NOTE: For best results, allow the glue to dry before printing .
NOTE: The printer will load the print file.
NOTE: The estimated time to completion is noted at the bottom of
the screen .
NOTE: The blue bar at the top is also a progress indicator that shows
the status of the loading process .
NOTE: The print jets will begin to heat .
CAUTION: Do not touch the print jets until they have cooled to room
temperature .
NOTE: The estimated time to completion is noted at the bottom of
the screen .
NOTE: The blue bar is a progress indicator that shows the status of
the print jet heating process .
NOTE: The blue bar is a progress indicator that illustrates the status
of the print .
NOTE: Select PAUSE
you wish to cancel the print job .
NOTE: Press the time at the bottom of the screen to view the
percentage of completion . Press it again to view how many layers
have been printed . After a few seconds, the default time will appear
again .
NOTE: If you selected
again to confirm your decision. Otherwise, select
continue printing .
3D Systems, Inc.
to temporarily stop printing . Select
CANCEL to cancel the print, select
CANCEL if
CANCEL
RESUME to
29