3D Systems cube User Manual page 87

This printer is portable with a plug and print design that enables everybody in the family to express their creativity like never before

Hide thumbs Also See for cube:

Table of Contents

8 .

Reinstall the print pad and select the

procedure again .

NOTE: Select

SKIP

recommended that Auto Level procedure is performed again .

9 .

Once Auto Level is successful, the printer will being checking the Z-gap .

NOTE: The printer will perform an automated gap measurement .

This may take a few minutes .

10 . Select the

checkmark

NOTE: If Auto Gap is not successful, it is recommended that you

perform Auto Level and Auto Gap again . Select

continue .

NOTE: If Auto Gap is not successful the second time, select

MAINTENANCE . For more information, refer to the section titled

Print Pad Maintenance . Once the Plate Maintenance procedure has

been performed, perform Auto Level and Auto Gap .

NOTE: If Auto Gap is still not successful, select

ADJUSTMENT . Refer to the section titled Manual Gap Adjustment for

more information . Once the Manual Gap Adjustment procedure has

been performed, note the final reading for future reference.

3D Systems, Inc.

checkmark

to perform the Auto Level

to bypass the Auto Level procedure . It is

to continue .

AUTO LEVEL

PLATE

MANUAL GAP

Table of Contents