Test Print - 3D Systems cube User Manual
This printer is portable with a plug and print design that enables everybody in the family
to express their creativity like never before
Hide thumbs
Also See for cube:
- User manual (121 pages) ,
- Quick start manual (32 pages) ,
- Lesson (15 pages)
Table of Contents
Advertisement
TEST PRINT
Test print allows you to print the same welcome message that is printed during the initial setup of the printer . The print is very useful for
determining if the gap between the left print jet and the print pad is correct .
TEST
PRINT .
1 .
Select
2 .
Select PRINT .
NOTE: If the color built into the test print does not match a
color of one of the installed cartridges, the printer will assign an
installed cartridge color to the test print .
3 .
Apply two thin layers of Cube Glue to the print pad . Select the checkmark to
continue .
NOTE: Apply enough glue to cover a square area of 5" (15 cm) .
NOTE: For best results, allow the glue to dry before printing .
3D Systems, Inc.
87
Advertisement
Table of Contents
