Console Event Log; Sample Power-Up Configuration Screen - DEC 4000 AXP Service Manual

Figure 2–10 Sample Power-Up Configuration Screen
Console Vn.n-nnnn
CPU 0 P
CPU 1 -
Memory 0 -
Memory 1 -
Memory 2 -
Memory 3 P
Ethernet 0 P
Ethernet 1 P
P
A SCSI
B DSSI P
C DSSI P
D DSSI P
E SCSI P
Futurebus+ P
System Status Pass
>>>

2.2.1 Console Event Log

DEC 4000 AXP systems maintain a console event log consisting of status
messages received during power-on self-tests. If there are problems during
power-up, standard error messages may be embedded in the console event log. To
display a console event log, use the
Use the
set screen_mode off
log during power-up, rather than the two power-up screens.
The following example shows an abbreviated console event log that contains two
standard error messages: The first (a hard error) indicates a failure with storage
bus B. This failure could be caused by a bad LDC, improperly seated storage
drawer, or a disconnected power cable within the storage drawer. The second (a
soft error) indicates a SCSI continuity card is missing from the removable-media
storage compartment.
VMS PALcode Xn.nnX, OSF PALcode Xn.nnX
TM
B2001-AA DECchip 21064-2
B2002-DA 128 MB
Address 08-00-2B-2A-D6-97
Address 08-00-2B-2A-D6-A6
ID 0 ID 1 ID 2 ID 3
RZ73
RF73
TZ85 RRD42
FBA0 - -
Type b to boot dka0.0.0.0.0
cat el command.
command if you want to display the console event
Power-On Diagnostics and System LEDs 2–17
ID 4 ID 5 ID 6 ID 7
Host
Host
Host Host
Host Host
Host
- - -
LJ-02267-TI0