2.6.2 Connecting the DEC Power Bus Cable (PN 70-31534-01)
Use the following procedure to connect the DEC power bus cable from the LSB
chassis to a power sequencing power controller similar to Digital's model 877-E
that is included in an H9702-FB cabinet.
1. Connect one end of the DEC power bus cable to the power bus connector
located behind the top left edge of the LSB front panel (see Figure 2–12).
Figure 2–12 DEC Power Bus and Console Cable Connectors
Console
Connector
Front
2. Route the DEC power bus cable toward the rear of the LSB chassis.
3. Open the rear door on the equipment cabinet.
4. Connect the other end of the DEC power bus cable to the power controller
that is mounted on the rear cabinet rails behind the LSB chassis.
DEC Power Bus
Connector
Console Cable
Ground Stud
Installation
MK−2339−19
Installation 2–23