Configuration Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

9.1.2 Configuration Commands

9.1.2.1 interface tunnel
This command uses to enter the Interface Config mode for a tunnel interface. The <tunnel-id> range is 0
to 7.
Syntax
interface tunnel <0-7>
no interface tunnel <0-7>
no - This command removes the tunnel interface and associated configuration parameters for the
specified tunnel interface.
Default Setting
None
Command Mode
Global Config
9.1.2.2 tunnel source
This command specifies the source transport address of the tunnel, either explicitly or by reference to an
interface.
Syntax
tunnel source {<ipv4-address> | <ethernet> {<slot/port> | vlan <vlan-id>}}
<slot/port> - The Interface number.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
<ipv4-address> - A valid IP Address.
Default Setting
None
Command Mode
Interfacel Tunnel Mode
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
860/1523