Managing Radius - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

11.4.4 Managing RADIUS

11.4.4.1 Configuring RADIUS Configuration Page
Configurable Data
Max Number of Retransmits - The value of the maximum number of times a request packet is
retransmitted. The valid range is 1 - 15. Consideration to maximum delay time should be given when
configuring RADIUS maxretransmit and RADIUS timeout. If multiple RADIUS servers are
configured, the max retransmit value on each will be exhausted before the next server is attempted.
A retransmit will not occur until the configured timeout value on that server has passed without a
response from the RADIUS server. Therefore, the maximum delay in receiving a response from the
RADIUS application equals the sum of (retransmit times timeout) for all configured servers. If the
RADIUS request was generated by a user login attempt, all user interfaces will be blocked until the
RADIUS application returns a response.
Timeout Duration (secs) - The timeout value, in seconds, for request retransmissions. The valid
range is 1 - 30. Consideration to maximum delay time should be given when configuring RADIUS
maxretransmit and RADIUS timeout. If multiple RADIUS servers are configured, the max retransmit
value on each will be exhausted before the next server is attempted. A retransmit will not occur until
the configured timeout value on that server has passed without a response from the RADIUS server.
Therefore, the maximum delay in receiving a response from the RADIUS application equals the sum
of (retransmit times timeout) for all configured servers. If the RADIUS request was generated by a
user login attempt, all user interfaces will be blocked until the RADIUS application returns a
response.
Dead Time - The dead time value, in seconds. The valid range is 1 - 255. - Selects if the RADIUS
accounting mode is enabled or disabled.
Accounting Mode - Selects if the RADIUS accounting mode is enabled or disabled.
Enable Radius Attribute 4 (NAS-IP Address) –To set the network access server (NAS) IP address
for the RADIUS server, select the option and enter the IP address of the NAS in the available field.
The address should be unique to the NAS within the scope of the RADIUS server. The NAS IP
address is only used in Access-Request packets. By default this mode is disabled.
NAS-IP Address - The NAS-IP-Address of the RADIUS authentication client referred to in this table
entry. By default it is not configured.
Non-Configurable Data
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
1261/1523