Autoinstall Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

6.16.17 AutoInstall Commands

The AutoInstall feature enables the automatic update of the image and configuration of the switch. This
feature enables touchless or low-touch provisioning to simplify switch configuration and imaging.
AutoInstall includes the following support:

Downloading an image from TFTP server using DHCP option 125. The image update can
result in a downgrade or upgrade of the firmware on the switch.

Automatically downloading a configuration file from a TFTP server when the switch is booted
with no saved configuration file.
When the switch boots, it attempts to obtain an IP address from a network DHCP server. The response
from the DHCP server includes the IP address of the TFTP server where the image and configuration
flies are located.
After acquiring an IP address and the additional relevant information from the DHCP server, the switch
downloads the image file or configuration file from the TFTP server. A downloaded image is utomatically
installed. A downloaded configuration file is saved to non-volatile memory
6.16.17.1 Show Commands
6.16.17.1.1 show autoinstall
This command displays the current status of the AutoInstall process.
Syntax
show autoinstall
Default Setting
None
Command Mode
Privileged Exec
Display Message
AutoInstall Operation: Displays the autoinstall operation is started or stoped.
AutoInstall Persistent Mode: Displays the autoinstall persistently for next reboot cycle.
AutoSave Mode: Displays the autoinstall persistently for next reboot cycle.
AutoReboot Mode: Displays the auto-save of downloaded configuration.
AutoUpgrade Mode: Displays the upgrade mode, which is used to allow to download the newer
image.
AutoInstall Retry Count: Retry Count The number of times the switch has attempted to contact the
TFTP server during the current AutoInstall session.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
527/1523