Configuration Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

9.3.2 Configuration Commands

9.3.2.1 ipv6 hop-limit
This command defines the unicast hop count used in ipv6 packets originated by the node. The value is
also included in router advertisements. Valid values for <hops> are 1-64 inclusive. The default "not
configured" means that a value of zero is sent in router advertisements and a value of 64 is sent in
packets originated by the node. Note that this is not the same as configuring a value of 64.
Syntax
ipv6 hop-limit <hops>
no ipv6 hop-limit
no – Use this command to disable the forwarding of IPv6 hop-limit.
Default Setting
not configured
Command Mode
Global Config
9.3.2.2 ipv6 unicast-routing
Use this command to enable the forwarding of IPv6 unicast packets.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
no – Use this command to disable the forwarding of IPv6 unicast packets.
Default Setting
Disabled
Command Mode
Global Config
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
877/1523