Capture Cpu Packet Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.
6.16.18

Capture CPU packet commands

6.16.18.1 Show commands
6.16.18.1.1 show capture
Use this command to display packets captured and save to RAM, It is possible to capture and save into
RAM, packets that are received or transmitted throuph the CPU. A maximum 128 packets can be saved
into RAM per capturing session. A maximum 128 bytes per packet can be saved into the RAM. If a
packet holds more than 128 bytes, only the first 128 bytes are saved; data more than 128 bytes is
skipped and cannot be displayed in the CLI.
Capturing packets is stopped automatically when 128 packets are captured and have not yet been
displayed during a capture session. Captured packets are not retained after a reload cycle.
Syntax
show capture [packets]
<packets> - Specifies this parameter to display the captured packets on the CLI.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Operational Status: Displays capture status.
Current Capturing Type: Displays the current capturing type. Possible types are Line, File, and
Remote.
Capturing Traffic Mode: Displays the capturing traffic mode. Possible modes are Rx, Tx, or Tx/Rx.
Line Wrap Mode: Displays the line wrap mode for Line capturing type. Default is disabled.
RPCAP Listening Port: Displays the pcap listening port number. Default listening port number is
2002.
RPCAP dump file size (KB): Disaply the capture packet file size. Default file size is 512KB.
Capturing Interface: Display the capturing interface.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
531/1523