Managing Igmp Snooping Querier - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

11.3.19 Managing IGMP Snooping Querier

11.3.19.1 Configuring IGMP Snooping Querier Configuration Page
Use this menu to configure the parameters for IGMP Snooping Querier, Note that only a user with
Read/Write access privileges may change the data on this screen.
Selection Criteria
Snooping Querier Admin Mode - Select the administrative mode for IGMP Snooping for the switch
from the pull-down menu. The default is disable.
Configurable Data
Snooping Querier Address - Specify the Snooping Querier Address to be used as source address
in periodic IGMP queries. This address is used when no address is configured on the VLAN on
which query is being sent.
IGMP Version - Specify the IGMP protocol version used in periodic IGMP queries.
Query Interval - Specify the time interval in seconds between periodic queries sent by the snooping
querier. The Query Interval must be a value in the range of 1 and 1800. The default value is 60.
Querier Expiry Interval - Specify the time interval in seconds after which the last querier information
is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default
value is 60.
Command Buttons
Submit - Update the switch with the configured values.
Refresh - Reload the information on the page.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
1171/1523