Configuration Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

9.4.2 Configuration Commands

9.4.2.1 ipv6 ospf
This command enables OSPF on a router interface or loopback interface.
Syntax
ipv6 ospf
no ipv6 ospf
<no> - This command disables OSPF on a router interface or loopback interface.
Default Setting
Disabled
Command Mode
Interface Config
9.4.2.2 ipv6 ospf areaid
This command sets the OSPF area to which the specified router interface belongs. The <areaid> is an
IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the range of
<0-4294967295>. The <areaid> uniquely identifies the area to which the interface connects. Assigning
an area id, which does not exist on an interface, causes the area to be created with default values.
Syntax
ipv6 ospf areaid <areaid>
<areaid> - is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in
the range of <0-4294967295>.
Default Setting
None
Command Mode
Interface Config
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
908/1523