Managing Access Control Lists - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

11.4.7 Managing Access Control Lists

11.4.7.1 Configuring IP Access Control List Configuration Page
An IP ACL consists of a set of rules which are matched sequentially against a packet. When a packet
meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken and the additional
rules are not checked for a match. On this menu the interfaces to which an IP ACL applies must be
specified, as well as whether it applies to inbound traffic. Rules for the IP ACL are specified/created
using the IP ACL Rule Configuration menu.
Selection Criteria
IP ACL - Make a selection from the pulldown menu. A new IP Access Control List may be created or
the configuration of an existing IP ACL can be updated.
Configurable Data
IP ACL ID - IP ACL ID must be a whole number in the range of 1 to 99 for IP Standard Access Lists
and 100 to 199 for IP Extended Access Lists.
IP ACL Name - Specifies IP ACL Name string which includes alphanumeric characters only. The
name must start with an alphabetic character. This field displays the name of the currently selected
IP ACL if the ACL has already been created.
Non-Configurable Data
Table - Displays the current and maximum number of IP ACLs.
Current Size - The current number of IP ACLs.
Max Size - The maximum number of IP ACLs.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Delete - Removes the currently selected IP ACL from the switch configuration.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
1274/1523