Ospfv3 Commands; Show Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

9.4 OSPFv3 Commands

This section describes the commands you use to configure OSPFv3, which is a link-state routing
protocol that you use to route traffic within a network.

9.4.1 Show Commands

9.4.1.1 show ipv6 ospf
This command displays information relevant to the OSPF router.
Syntax
show ipv6 ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
NOTE: Some of the information below displays only if you enable OSPF and configure certain
features.
Router ID: Is a 32 bit integer in dotted decimal format identifying the router, about which information
is displayed. This is a configured value.
OSPF Admin Mode: Shows whether the administrative mode of OSPF in the router is enabled or
disabled. This is a configured value.
External LSDB Limit: Shows the maximum number of non-default AS-external-LSAs entries that
can be stored in the link-state database.
Exit Overflow Interval: Shows the number of seconds that, after entering Overflow State, a router
will attempt to leave Overflow State.
Autocost Ref BW: Shows the value of auto-cost reference bandwidth configured on the router.
Default Passive Setting: Shows whether the interfaces are passive by default.
Maximum Paths: The maximum number of paths that OSPF can report for a given destination.
Default Metric: Default value for redistributed routes.
Default Route Advertise: Indicates whether the default routes received from other source protocols
are advertised or not.
Always: Shows whether default routes are always advertised.
Metric: The metric of the routes being redistributed. If the metric is not configured, this field is blank.
Metric Type: Shows whether the routes are External Type 1 or External Type 2.Number of Active
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
890/1523