Ipv6 Routing Commands; Show Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

9.3 IPv6 Routing Commands

This section describes the IPv6 commands you use to configure IPv6 on the system and on the
interfaces. This section also describes IPv6 management commands and show commands.

9.3.1 Show Commands

9.3.1.1 show ipv6 brief
This command displays the IPv6 status and IPv6 unicast routing mode.
Syntax
show ipv6 brief
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
IPv6 Unicast Routing Mode: Shows whether the IPv6 unicast routing mode is enabled.
IPv6 Hop Limit：Shows the unicast hop count used in IPv6 packets originated by the node. For
more information, see "ipv6 hot-limit"
ICMPv6 Rate Limit Error Interval：Shows how often the token bucket is initialized with burst-size
tokens. For more information, see "ipv6 icmp error-interval"
ICMPv6 Rate Limit Burst Size：Shows the number of ICMPv6 error messages that can be sent
during one burst-interval. For more information, see "ipv6 icmp error-interval"
Maximum Routes：Shows the maximum IPv6 route table size.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
864/1523