Meters; Setting The Fader Meters On Each Strip; Screen Meters On The Touchscreen - Euphonix Max Air Manual

Euphonix Max Air Mixing Console Operations Manual
3.5

Meters

After channels are assigned to the surface, set the meters to suit your needs.
3.5.1

Setting the Fader Meters On Each Strip

We recommend beginning here since you will be able to see signal when you patch into
the channel.
1. Select Meters from the Main Menu.
2. Select the
This view shows all available Strips on your Max Air Console.
3. Select All, then choose Fader in the Meter Display area to the right to en-
Touch
able the meter next to each fader on the Strips.
When you begin patching audio into console, you will now see signal on each
channel as you patch.
3.5.2

Screen Meters on the Touchscreen

There are eight meter banks across the top and down the right side of the Touchscreen.
You can choose from a wide variety of signals to display here. Since there are meters set
up on every channel, it is probably best to select the screen meter area to display Sub-
groups, Aux Masters, Solo, and Program. In this example we will place the meters for
these busses on the screen.
1. Select Meters from the Main Menu.
2. Select the
3.
Select the left-most meter bank area (selected bank shows a yellow outline box).
4.
To select the four stereo subgroup masters we created earlier, press the
tions button in the Function area.
5. Select Main section
You will see the SubA stereo meters appear in the selected bank.
6.
Select the adjacent meter bank to the right and repeat above steps until SubA,
SubB, SubC, and SubD meters are visible.
On the fifth meter bank from the left, place eight Aux masters:
7. Select the fifth meter bank area from the left.
8. Aux Busses from the Function area – the available aux busses buttons ap-
Select
pear on the right area of the screen.
Fader tab.
Screen tab.
A (labeled SubA in the Main Section box).
37
Quickstart to Common Tasks
Main Sec-