Mix Minus; Mix Minus Processing - Euphonix Max Air Manual

Euphonix Max Air Mixing Console Operation Manual
5.6

Mix Minus

Each channel has a mix minus output that can be used to send a unique feed to an an-
nouncer. The Mix Minus Reference Bus is the console's single mono mix minus bus. A
channel is routed to it by pressing the Bus key. Pressing the Main- key creates a feed
for an announcer's ear piece on the channel's mix minus output. The channel's signal is
subtracted from the mix minus bus, allowing the announcer to hear all voices on the bus
except their own.
To enable talkback functions:
1.
Physically connect the CM404's rear panel
XLR to the MC524's Talkback 1 input.
2. Physically connect the MC524's
AM713.
3.
In the Patch view, patch the A/D Source into the
In.
Holding down the Talk key (located to the left of the Swap key above the fader) switch-
es the talkback mic into the channel's mix minus output.
Pre
Fader
Post
Processing
The Pre/Post Selector is set from the Mix Minus Bus Configuration view on the Touch-
screen (see Mix Minus on page 119). It is not controlled from the channel strip.
There is a gain control just before the Mix Minus Output. This is controlled from the Mix
Minus Bus Configuration view on the Touchscreen. It is not set from the channel strip.
Talkback 1 output to a spare A/D input on an

Mix Minus Processing

On
-
Subtract
Off
Pre
Switch
Off
Off
On
Off On
Bus Switch
To
Mix Minus
Ref Bus
Figure 5-18
Mix Minus Processing
110
External or Internal Talkback Mic
Utility Destinations/Slate-TB_
From
+
Mix Minus
Ref Bus
On
Mix-
Switch
Mix Minus Output
Gain
Talk
Switch
From
Talkback
Mic
Channels and Strips