Max Air Startup Sequence - Euphonix Max Air Manual

Euphonix Max Air Mixing Console Operation Manual
1.4

Max Air Startup Sequence

With all system components turned off:
1.
Turn on all of the surface modules.
2.
Turn on the SC263 System Computer
3. Make sure the system digital sync source and Eucon switch is on.
4. Turn on the Failover Switch (if present), all I/O units, the MOTU MIDI Interface
and the GP132.
5.
The System Computer will finish booting to the Windows desktop.
With the system computer booted and the Failover Switch (if present), all I/O units, the
MOTU MIDI Interface and the GP132 turned on:
1. Double-click the
2. Turn on the DF66.
3. If the modules on the system have previously been saved as default, Max Air will
continue to boot when all modules reach 100%.
4.
If modules appear as
down the Ctrl key on the keyboard and selecting each of them. When all modules
are selected, touch Save selected as default, and confirm the selection by clicking
OK.
5. Click Continue to finish booting.
Since Max Air has been designed for live, on-air applications, the system is designed
to tolerate variations in the startup sequence. The system will boot properly if power is
applied to all components simultaneously. If this occurs, be sure to check that all com-
ponents are properly locked to a valid master digital sync source.
To restart the system:
1. Shutdown the System PC with the
2.
Reset the CM404 and CM416 surface modules.
3.
Power off the DF66 core.
4. Power on the System PC.
Since this takes the longest to boot, power it up first.
5. Power on the DF66.
The DF66 must be off for 5 s before powering back on to discharge the PSUs.
6. The system will boot the rest of the way by itself.
Max Air icon on the desktop.
Unexpected, the user can select all of the modules by holding
Shutdown button in the About View.
23
Introduction