Aux Busses; Aux Bus Knobset - Euphonix Max Air Manual

Euphonix Max Air Mixing Console Operation Manual
5.3.6

Aux Busses

The CM404 Center Section has Bus Master functions. See page 118 to configure Aux
busses as stereo pairs.
Aux busses can be mono or stereo pairs. Each Aux bus can be configured as pre- or post-
fader. Press the Aux Knobset Select key to assign the Aux bus parameters to the knobs.
Aux bus assignments are displayed at the top of the strip. Pre-fader sends are displayed
in yellow; post-fader sends are in green.
Figure 5-14 shows the first four Aux busses with 1/2 set to a stereo pair and others to
mono. Press the ► key to display additional busses. Stereo busses use two knobs:
• The Pan knob (top) adjusts the stereo Pan and its lower-left key switches Pan in/
out.
• The Gain knob (labeled with the send numbers) adjusts the overall Gain for both
sends and its lower-left key switches the pair in/out. The upper-left key switches
the send from post- to pre-fader.
• Mono busses use one Gain knob and its lower-left key switches the send in/out.
The upper-left key switches the send from post- to pre-fader.
Page 1
Pan
Select
Pan in/out
On
1/2
Select
pre/post
on/off
On
3
Select
pre/post
on/off
On
4
Select
pre/post
on/off
On
Copy Paste
Figure 5-14

Aux bus Knobset

106
Channels and Strips
Aux 1/2 Pan
Aux 1/2 Gain
Aux 3 Gain
Aux 4 Gain