Euphonix Max Air Manual page 35

Euphonix Max Air Mixing Console Operations Manual
Placing Main Busses on the Center Section (CM404)
1. Press the
sign" tab. In the upper block, select the Main Sections tab to display the Main/
Mix busses. Select Sections A through E and in the lower Strip block, select the
Center tab. Touch the button representing Center Strip 1 and Main Sections A
through E will be displayed on the first five center faders.
2.
Press the
the Super Channel page.
3. On Main Section "A" (SubA), press the
fader) in order to display that channel's parameters and assignments on the Super
Channel.
4.
In the upper left corner of the Super Channel display, press the
the Group/Main/Aux assignment box. A pop-up window appears allowing you to
assign that Main (SubA) section to the PGM Section "E". Take care to not assign
a section to itself: e.g. do not route Main Section A to Main Section A, as feedback
will result.
5. Once SubA is assigned to PGM, press the wave key on the fader representing
SubB. The assignment pop-up stays open, but now reflects SubB's routing As-
sign SubB to PGM. Repeat this process for the two remaining sections (SubC and
SubD) and close the assignment pop-up window.
6. You have now routed your four Sub Sections A-D to the PGM output bus E.
7. Depending on your Mixer Model, it may be desirable to add buss processing (com-
pression and limiting) to the output bus and sub sections. Please refer to Chapter
6, pages 111-125 for details on assigning processing to busses.
Surface button on the right side of the touch screen and select the "as-
Super Channel button on the right side of the touch screen to bring up
Figure 3-2
35
Quickstart to Common Tasks
Wave key (blue Euphonix logo next to the
Setup button in