Euphonix Max Air Manual page 99

Euphonix Max Air Mixing Console Operation Manual
Analog Controls
If an ML530 Mic/Line Interface or Modular I/O Remote Preamp is patched to the input,
the knobs show the analog mic/line controls:
• HiZ : Press the lower key to the left of the knob to toggle the input between high
and low impedance. When the key is lit, the input is high impedance.
• 48V : Press the lower key to the left of the knob to toggle phantom power on/off.
When the key is lit, phantom power is on.
• HPF
: Press the lower key to the left of the knob to toggle the high-pass filter on/
off. When the key is lit, the high-pass filter is on.
• Gain : Rotate the knob to adjust the analog input gain between -12 and +72 dB.
The upper key toggles the A input on/off, and the lower key toggles the B input on/
off. Press both keys down to mix the A and B inputs together.
NOTE: There is a +12dB offset between the Gain knob dB reading and the Modular
I/O Remote Preamp's actual gain position. When the Gain knob displays
-12dB, the Modular I/O Remote Preamp's setting is 0dB.
If an ML530 Mic/Line Interface or Modular I/O Remote Preamp is not patched to the
input, the first page does not appear.
Digital Controls
The second page controls the digital parameters of the A and B inputs:
• Atrm: This knob adjusts the digital trim ±15 dB.
• Aphs: Press the lower key to the left of the knob to toggle the phase. The key lights
to indicate phase reversal. There is also a phase reversal light next to the fader.
• Dly: Press the lower key to the left of the knob to enable the delay. The key lights
to indicate the delay is active. Pressing the upper key to the left of the knob dis-
plays the delay knobset. The top knob adjusts the delay in one second increments.
The second knob down adjusts the delay in single frame increments. The third
knob down adjusts the delay in sub-frame increments. The bottom knob adjusts the
delay in single sample increments. The maximum amount of delay is 2 seconds.
• Inpt:
This knob selects between inputs A, B, and A+B (mixes both inputs).
Atrm and Aphs have corresponding controls for the B input; Dly and Inpt adjust one
parameter that applies to both inputs.
99
Channels and Strips