Ricoh CL7000 Setup Manual page 88

Installing Options
G G G G
Remove the protective cover on
the left side of the printer. Hold
the protective cover by both sides,
and while pushing the left side of
the cover (A A A A ), open it in the direc-
tion of the arrow (B B B B ), and then re-
move (C C C C ).
4
Note
❒ You cannot use the removed
protective cover.
H H H H
Attach the paper guide to the
stand. Hold it so that the right
side bends down as shown, and
then while gripping lightly (A A A A ),
insert it into the holes of the stand
(B B B B ).
76
I I I I
Insert the claws of the stand into
the holes on the left side of the
printer (A A A A ), and then push down
(B B B B ).
J J J J
Tighten the four long screws fas-
tening the duplex reversal unit
ZDJP041J
stand, using provided screwdriv-
e r . F a s t e n i n t h e o r d e r o f
A A A A ⇒ ⇒ ⇒ ⇒ B B B B ⇒ ⇒ ⇒ ⇒ C C C C ⇒ ⇒ ⇒ ⇒ D D D D , as shown.
This completes installation of the
stand. Next, install the duplex re-
versal unit.
ZDJP042J
ZDJP043J
ZDJP044J