Ricoh CL7000 Setup Manual page 80

Installing Options
F F F F
Put the controller board down on
a flat surface.
You must install the user account
enhance unit in the position as
shown.
4
G G G G
Install the user account enhance
unit into the controller board. If
there is a screw coming out from
the place of attachment, insert the
screw in the hole at the tip of the
user account enhance unit (A A A A ),
and then push the unit in the di-
rection of the arrow (B B B B ).
Check the user account enhance
unit is connected firmly to the con-
troller board.
68
H H H H
Tighten the screw fastening the
user account enhance unit, using
the provided screwdriver.
I I I I
Align the controller board with
ZDJP702J
the top and bottom rails, and then
push in slowly, until it stops.
J J J J
Tighten the two screws fastening
the controller board back into its
original position, using the pro-
vided screwdriver.
ZHXP020N
ZHXP270N
ZDJP030J
ZDJP031J