Ricoh CL7000 Setup Manual page 78

Installing Options
J J J J
With the side labeled INSERT
facing up, slowly insert the card
into the Bluetooth unit, until it
stops.
4
K K K K
Insert the controller board into
the top and bottom rails, and then
slide it in slowly, until it stops.
L L L L
Tighten the two screws fastening
the controller board back into its
original position, using the pro-
vided screwdriver.
66
M M M M
Press the antenna to extend it.
N N N N
Attach the antenna cap over the
antenna.
ZHXP060J
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
❒ After finishing the installation,
you can check the Bluetooth
unit is installed properly: Print
the configuration page from the
"List/Test Print" menu. If it is
installed properly, you will see
" B lu e too th" a p pea r u n d e r
"Controller Option".
ZDJP030J
❒ If the Bluetooth unit is not in-
stalled properly, repeat the pro-
cedure from step
cannot install it properly even
after reinstallation, contact your
sales or service representative.
Reference
p.23 "Test Printing"
ZHXP220J
ZHXP030N
A
. If you